VARNISH E 200

Insulating varnish for protecting printed circuit boards, electrical windings, and fixed assemblies, which can also be used in humid conditions.

Perfect insulation.
Quick-drying at room temperature and relative humidity, can be accelerated in the oven.
Excellent thermal conductivity.
Resistant to mechanical impact.
Allows soldering without removing the protective film.
Contains a UV tracer that produces a fluorescent blue reflection when exposed to UV light.

Wide range of applications in the electronics and electrical industry, aerospace, automotive industry, marine, and telecommunications.

Before applying Electrofuge 200, the parts to be treated must be thoroughly degreased.

Aerosol: Shake well for at least one minute after the mixing ball is free. Spray Electrofuge 200 from a distance of 25 cm from the surface. Apply several thin cross coats and make sure that the paint does not run.
Brush or spray gun: It is recommended to dilute the product with 5 to 20% thinner. Apply carefully to the parts to be treated.
Immersion: Preferred technique for protecting the underside of components for use in aggressive environments. Immerse and allow excess product to drain off.

Silicone-based, insulating protective coating with UV tracer.

Physical properties
Color	Colorless, slightly cloudy, Colorless, slightly cloudy
density	0.80-0.95, 0.80-0.95
solids content	34–38%, 34–38%

product information
container	400 ml
Viscosity (mPa·s)	20 - 30, 20 - 30

Performance at ultimate strength
dielectric strength	≥ 80 kV/mm, ≥ 80 kV/mm
volume resistance	≥ 1.10^14 Ω.cm, ≥ 1.10^14 Ω.cm

keywords
keywords	Insulating varnish for printed circuit boards Fast-drying protective coating UV tracer for fluorescent inspection Silicone-based insulating varnish Hard, resistant film Solderable Good heat dissipation Shockproof